| 1. | Gets the keyboard repeat - speed setting
获取键盘重复速度设置。 |
| 2. | Speed sets the speed for the connection 9600 bits per second
Speed是设置连接速度9600波特率。 |
| 3. | Revolution speed set up time
旋转速度建立时间 |
| 4. | Enable manual user - selected aperture and shutter speed settings for individual creative effects or difficult lighting conditions
在光线条件很差或要求特殊的效果时,能让您手动选择光圈和快门速度值。 |
| 5. | In the program ae mode the camera automatically determines the optimum aperture and shutter speed settings for each shot
使用程序自动曝光模式时， dimageg400会自动决定每个影像的最佳光圈和快门速度设定。 |
| 6. | Enables manual user - selected aperture and shutter speed settings for individual creative effects or difficult lighting
在各别情况下,为达到独特的拍摄效果或在很差的光线条件下拍摄,可用手动选择光圈和设定快门速度。 |
| 7. | The best speed setting for the machine is the slowest possible setting with the optimum product spacing to achieve the desired machine throughput
机器的最佳速度设置是尽量低的设置，使之能产生最佳的产品间距，以便达到机器预期的处理量 |
| 8. | Then the 3 - way magnet valve ( pos . no . 73 ) is deenergized and the speed setting signal raised by the manoeuvring valve ( pos . no . 01 - ) is transmitted to the p . g . governor again
三通电磁阀73决不会断电，但通电的原因被消除而且主机安保系统电气回路被复位。 [是否有误？ |
| 9. | Temperature setting and production cycle settings of the arms are on the same panel with user - friendly simple operation procedures . individual speed settings on each arm can accommodate different production requirements
六、烘房温度、旋臂等参数的调节设于同一控制系统，操作简易。独立调节各旋臂的转速，满足不同产品的生产条件。 |
| 10. | Using the system designed in this thesis work , flow field calibration of the wind tunnel is accomplished , which covers dynamic pressure drop coefficient , dynamic pressure time stability , axial static pressure gradient , boundary layer , and degree of turbulence , etc . boundary layer measuring principle and method are especially described in detail , the relationship between boundary layer thickness , wind speed setting , and the depth of the experimental section is summarized , and finally the calibration data for th e model center zone under specific wind speed are given
然后利用本文设计的系统完成了落差系数、动压时间稳定姓、轴向静压梯度、边界层及湍流度等内容的流场校测。特别对边界层测量的原理及方法做了较详尽的叙述，总结出边界层厚度与设定风速、实验段深度的关系，然后给出模型中心区一定风速下校正数值。 |
